Weaverline Feed Cart and Chopper Dealer in Central New York

Showing all 7 models

Weaverline feed cart

Weaverline Series 5 Feed Cart

Battery-powered stainless steel feed cart, built as models 521, 525, 531 and 537

35sec. to unload 31 bu. of corn silage

4models: 521, 525, 531, 537

30+cart loads per charge, good batteries

13" to 30"high discharge option

• Stainless steel box section and stainless steel augers
• All-stainless conveyor: gap-link chain, sprockets and slats
• Hydrostatic drive with fingertip forward and reverse control
• Self-centering chain on narrow sprockets for low wear
• Free-wheeling lever to move the cart without the motor

Full specifications

Power	Battery power
Drive	Hydrostatic drive
Box section	Stainless steel
Augers	Stainless steel
Conveyor	Stainless gap-link chain, stainless steel sprockets, and stainless steel slats
Unloading	31-bushel cart of corn silage in 35 seconds
High Discharge Box	13" to 30" discharge height
Pneumatic Tires	adds 6-1/2" to the width of the cart
Extension Side Kit	6" and 12" extensions available

Source: Weaverline Feed Cart page.

Weaverline bale chopper

Weaverline KB1255 Bedding Chopper

Chops a bale of straw in less than 60 seconds with a 13 HP Honda

13HP Honda

76knife spiral rotor

<60sec. per bale

6grate settings

• Adjustable grate with six settings for output and cut length
• Fold-up carrier for an extra bale
• Knife plates on a 1-1/4" hex shaft flip once to use both edges
• Plastic top overlay and wear strip help prevent binding, which matters most with newspaper
• Steel bale hopper turned by an enclosed oil bath gearbox

Full specifications

Power	13 HP Honda
Other power options	9 HP Honda or Briggs & Stratton (economy models); electric motor
Rotor	76-Knife rotor with a spiral design
Rotor shaft	Heavy Duty 1-1/4" Hex Shaft
Rotor drive	Double V-belt drive
Grate	Adjustable, six settings
Discharge	Bottom discharge model available
Rotor access	Tilt-top
Hopper drive	Enclosed oil bath gearbox, hopper rotates on four large bearings
Chopping time	less than 60 seconds per bale

Source: Weaverline Bedding Chopper page.

Weaverline bale chopper

Weaverline T.M.R. Chopper

Processes dry hay or straw before it goes into a T.M.R. mixer

3 or 5HP electric motor

2discharge layouts

• Bottom discharge unit on a stand for mounting over a conveyor
• Floor-mounted unit with blower and gooseneck to fill a mixer
• Spiral rotor for uniform cutting with less horsepower
• Weaverline says pre-chopping cuts mixer run time and improves the mix

Full specifications

Power	3 HP or 5 HP electric motor
Rotor	Aggressive rotor with a spiral design
Discharge	Bottom discharge with stand, or floor mounted with blower and gooseneck
Rotor access	Tilt-top
Material	Dry hay or straw

Source: Weaverline T.M.R. Chopper page.

Weaverline silage packer

Weaverline Silage Packer

Three-point packer with 30" steel wheels and sand-filled weight boxes, models 2907, 2909 and 2911

30"steel wheels

1,000lbs. per wheel (approx.)

5"steel-tube axle

Cat 33-point hitch

• Weight boxes filled with sand put about 1,000 lbs. on each wheel
• Steel disc wheels with a 3-inch stainless steel rim
• Heavy-duty axle in bronze bushings, 1/2" steel frame
• Three models: 2907, 2909 and 2911
• Category 3 three-point hitch

Full specifications

Wheels	30" steel wheels
Wheel construction	steel discs with a 3-inch wide stainless steel rim
Weight per wheel	approximately 1,000 pounds per wheel (weight boxes filled with sand)
Axle	heavy-duty 5" steel-tube axle, bronze bushings
Frame	1/2 steel frame

Source: Weaverline Silage Packer page.

Weaverline straw mulcher

Weaverline Mulch Master KB1300

Engine-driven straw mulcher that mulches a bale in as little as 30 seconds

30sec. per bale

16 or 13h.p. engine

80%time saved vs. hand mulching

650lbs.

• 16 h.p. Briggs & Stratton Vanguard or 13 h.p. Honda engine
• Skid mounted to load on a pickup, truck or trailer
• Optional 30 ft or 40 ft flexible hose for tight spots
• Rotating gooseneck and hose handle kit options
• About 56" long, 34" wide and 49" high

Full specifications

Power	16 h.p. Briggs & Stratton Vanguard engine or a 13 h.p. Honda engine
Mounting	Skid mounted
Mulching speed	a bale of straw in as fast as 30 seconds
Hose	optional 30 ft or 40 ft. flexible hose
Options	rotating gooseneck and a hose handle kit

Source: Weaverline Landscape Mulcher page.

Weaverline straw mulcher

Weaverline Three-point PTO Mulcher

The Mulch Master configured as a three point hitch, PTO drive machine

PTOdrive

3-pointhitch

• Runs off the tractor PTO, no engine to maintain
• Carried on the three point hitch
• A configuration of the KB 1300 series Mulch Master

Full specifications

Power	PTO drive
Mounting	three point hitch
Hose	optional 30 ft or 40 ft. flexible hose

Source: Weaverline Landscape Mulcher page.

Weaverline debris blower

Weaverline Air Raid 218

PTO-driven, three-point debris and leaf blower for 20 to 74 HP tractors

6,000cfm at 540 rpm

20-74HP tractors

360°rotating fan cage

300lbs. (approx.)

• 6000 feet per minute of wind at 2 feet from the blower
• Fan cage rotates 360 degrees for the best blowing angle
• Category 1 three-point hook-up
• Uses about 7 HP at 540 rpm
• Model 218 in production since 2025, replacing the 118

Full specifications

Drive	PTO driven
Tractor size	20 HP to 74 HP
Hitch	category 1 three-point hook-up
Air volume	approximately 6,000 cfm at 540 PTO rpm
Wind speed	6000 feet per minute at 2 feet / 2,500 feet per minute at 10 feet
Power consumed	7 HP at 540 rpm
Weight	approximately 300 lbs.
Fan	rotates 360 degrees

Source: Weaverline Debris Blower page.

Nothing matches those filters. Clear filters

How Weaverline machines are built

• 

  01Stainless steel where feed touches

  Series 5 carts use a stainless box, stainless augers and an all-stainless conveyor. Weaverline says this greatly increases the life of the cart.

• 

  02Spiral chopper rotor

  The 76-knife spiral rotor gives an even power curve, so it cuts steadily with less horsepower. Knives sit on replaceable plates that flip once.

• 

  03Weight on the wheels, not the tires

  Sand-filled weight boxes put about 1,000 lbs. on each 30" steel packer wheel, so the pile is packed by narrow steel rims.

• 

  04Mulch where you need it

  With the optional 30 or 40 ft hose, the Mulch Master places straw in tight spots and hard-to-reach areas.

Feed cart special models and kits

Weaverline builds special versions of the feed cart and offers kits for different feeds and floors.

• Front and Side Unloading

  Drive into a bunk and feed full width out the front as you back out, then flip a lever for side feeding in the barn.

  Feed cart special model

• High Discharge Box

  13" to 30" discharge height for feeding into high mangers.

  Feed cart special model

• Hay Special

  Special augers and anti-wrap shields for feeding TMR with dry hay up to about 10" long.

  Feed cart special model

• Pneumatic Tires

  For outside travel. Adds 6-1/2" to the width of the cart.

  Feed cart

Also available

• Extension Side Kit

  Stainless steel, easy on and off. 6" and 12" extensions add capacity.

• Corn Baffle Kit

  For high-moisture corn and other semi-free-flowing feeds.

• Heavy-Duty Caster Wheel

  For rough floors or outside travel.

• Mulch Master hose and gooseneck

  30 ft or 40 ft hose, rotating gooseneck and hose handle kit.